At dusk in East Abbotsford the porch light clicked on, and past the steps the rest of the yard stayed black. Not dark in a cosy way. Black in a trip-over-the-hose way. The owners had a deck, a garden bed, a path to the side gate, and exactly one bulb doing all the work. Outdoor lighting installation cost BC — that is the question that follows, usually right after somebody stubs a toe. And the answer is annoyingly wide. A handful of path lights on a flat lot is one job. A full low-voltage system with a transformer, uplights on two cedars, deck lights, and a line-voltage run to the back fence is another job entirely. The gap between them can be several thousand dollars. The ranges below are 2026 planning ranges for BC, built from Fraser Valley component pricing. A budgeting aid. Not a quote.

Outdoor Lighting Installation Cost BC: The 2026 Ranges at a Glance

Start with the per-fixture view. It is the clearest way to price a yard, because most systems are just a count of lights plus the gear that feeds them. The table below shows installed ranges per fixture type, including the fixture, the cable share, and the labour to place it. Transformer and trenching sit outside these numbers. They come next.

Fixture typeTypical use2026 planning range (installed, per fixture)
Low-voltage path lightWalkways, garden edges$180 – $350
Low-voltage spot or uplightTrees, house walls, feature plants$220 – $450
Low-voltage deck or step lightDeck edges, stairs, rail posts$200 – $400
Low-voltage well lightGround-level wash, driveways$250 – $500
Line-voltage wall sconcePorch, garage, entry doors$250 – $550
Exterior pot light, soffitEaves, covered patios$280 – $550
Floodlight, motion sensorBack lane, side gate, parking pad$300 – $650
String lights, installed runPatios, pergolas, fences$400 – $1,200 per run

A typical small setup — eight to twelve low-voltage fixtures, all fed by a single transformer — generally lands between $2,500 and $6,000 installed. A mid-size system — fifteen to twenty-five fixtures split across two zones with a bigger transformer — generally runs $6,000 to $12,000 installed. At the top end, a large or line-voltage-heavy job — thirty fixtures or more, trenching across a big Clearbrook lot, a panel that needs room — can reach $12,000 to $20,000 or more. Landscape lighting installation cost — the phrase most people search — is really that middle band. Most yards end up there. Not the showroom job. Not the two-lights-and-done job. The middle.

Low-Voltage vs Line-Voltage: The Split That Decides Your Price

Here is the fork in the road. Nearly every quote splits here — 12-volt garden system or line-voltage — and that fork decides it. Bolted to the house wall, the transformer steps the power down to 12 volts, and thin cable runs from it to the fixtures — buried a few inches deep, or tucked under mulch. It is the safe option for paths and beds. It is the flexible option too. You can move a light in an hour. Add one next spring. Nobody is digging a deep trench for a 12-volt cable run through a flower bed. The fixtures cost less. The install costs less. The light sits softer and warmer in a garden bed than a harsh flood, and that warmth is why people pick it. The catch is distance. Voltage drops along a long run, so a fixture fifty metres from the transformer glows dimmer than the one five metres from the door, unless the cable is sized up or the run is split into zones. Big lots need planning. Small lots do not.

Line-voltage, 120-volt, is the house system. Pot lights under the eaves. Sconces by the door. Floodlights on the garage. It runs on the same power as the inside of your house, through conduit or armoured cable, installed by a licensed electrician under BC code. It is brighter. It is permanent. It is also more expensive per fixture, and the work is heavier — cutting, fishing cable through soffits, sometimes opening a wall. Exterior pot light cost BC sits in that line-voltage world. A single soffit pot light, installed, generally runs $280 to $550. A run of six under the eaves of a two-storey house in West Abbotsford, with a dimmer inside and a long cable pull through an attic that is hot in July and freezing in January, can add up fast. Six lights. One afternoon for the electrician if access is good. Two days if it is not.

Which does your yard need — garden, house, or a bit of both? Most yards need both, and that overlap is where quotes confuse people. The garden gets low-voltage. The house gets line-voltage. A quote that only prices one half is not a full quote. Ask which half it covers. Ask it plainly. The answer tells you more about the final bill than the fixture prices do.

Low-voltage path lights glowing along a garden walkway in an Abbotsford backyard at dusk
Low-voltage path lights are the cheapest way to light a walkway, and the cable stays shallow enough to move later.

The Transformer: A Small Box With an Outsized Effect on Cost

The transformer is the least glamorous part of the system. A grey box on the wall. Nobody photographs it, and nobody picks one for its looks, yet that grey box decides whether your lights work. The box takes the 120-volt supply from the house and steps it down to 12 volts for the garden, which lets the cable stay thin and shallow. Get the sizing wrong and the far fixtures go dim, while getting it right — wattage added up, headroom left in — means the whole yard glows evenly.

Size matters more than brand — transformers are rated in watts. To size one, add up the wattage of every fixture on the run, add twenty percent headroom, and that total is the size you need. Eight LED path lights at 5 watts each need a 60-watt transformer, roughly, once the headroom is in the number. A mid-size system with twenty fixtures, spots and uplights included, needs 150 to 300 watts, depending on the uplights in the mix. A large system with thirty or more fixtures, or a second zone for the front yard, needs 300 to 600 watts, or two transformers. The price follows the watts. Supplied and installed by the crew doing the job, a basic 150-watt transformer generally runs $300 to $700. A 300-watt unit, timer and photocell built in, comes in at $500 to $1,000 — the size most mid-size gardens need. A 600-watt or multi-zone unit for a big lot or two zones runs $900 to $1,800. The timer matters. A photocell switches the lights on at dusk and off at midnight, which saves power and saves you remembering in November. Skip the cheap timer that drifts — a system clicking on at 3 a.m. helps nobody. It will drift. They always do, right after the warranty.

Placement matters too, and it is the detail that gets skipped on a rushed quote, when nobody walked the yard first. The transformer wants a wall near the garden, sheltered from direct rain, close to an outdoor outlet or a new circuit — which narrows the options. Put it on the far side of the house from the garden and the whole job gets harder — longer runs, worse voltage drop, and thicker cable to price. Thicker cable costs more. Shorter runs cost less — it really is that simple — which is why a walk around the yard with the installer is worth ten minutes. Point at the wall. Point at the beds. Let them measure the distance — a five-minute walk can save a few hundred dollars in cable and a dim corner that bugs you every night.

Exterior Pot Lights and Soffit Work: Where the Bill Climbs

Backyard lighting cost is usually a low-voltage number. Exterior pot lights are not. They live under the eaves, wired into the house, and the install is fiddly in a way garden work never is. The electrician is up a ladder, working overhead, fishing cable through a soffit never designed to be opened again, which is slow, awkward work. On a single-storey house in Clayburn with a clear attic, four soffit pots might take half a day, the crew packed up before lunch. On a two-storey house in Auguston with a vaulted ceiling over the patio, though, the same four lights can take a full day, because there is nowhere to fish the cable except through the roofline or across finished ceilings. Access is the price driver. Not the fixture. The fixture is the cheap part.

Trenching, Labour, and the Fraser Valley Ground

Labour is the line that surprises people most, because it is the one line no showroom ever shows you. In 2026 an electrician in the Fraser Valley generally charges $90 to $150 per hour and a landscape lighting installer $70 to $120, and on bigger jobs a two-person crew is common — so the labour line is two people at once. A small garden system takes a day. A mid-size system takes one to two days. A line-voltage-heavy job with soffit work and a new circuit takes two to three days. Multiply it out and labour is often forty to fifty percent of the total. That is normal. It is not padding. It is the work.

Trenching is where the ground fights back, as anyone who has dug this clay in November rain knows. Low-voltage cable only needs a shallow slit a few inches deep, often cut with a spade and tucked under mulch — a crew finishes that in an afternoon. Cheap. Fast. Line-voltage cable needs depth, conduit, and code-compliant burial — a real trench, not a slit. In the heavy clay under Matsqui Prairie, a trench that should take an hour takes three — and the crew bills for the ground. On a rocky lot near Sumas Mountain, where the shovel keeps hitting stone, the same trench takes longer still. Trenching and conduit for a line-voltage run generally adds $500 to $2,000, and your ground decides where in that range you land. If the quote says trenching is included, ask how many metres that covers — if it is not on the page, it is not included. That distinction has ended friendships with contractors. Well, nearly.

Exterior pot lights glowing under the eaves of a Fraser Valley house at night
Soffit pot lights cost more per fixture than garden lights, because the cable run through the eaves is fiddly overhead work.

How to Keep the Bill Down Without Leaving the Yard Dark

A few habits keep the budget honest over a job that can drift fast. First, design in zones. Front yard on one zone, back garden on another, deck on a third — so each part lights on its own. Zones let you light only the part of the yard you are using. They also let you build in stages. Stage one this year, stage two next spring, same transformer if you bought the headroom. Second, pick LED everywhere. The fixtures cost a little more up front and use a fraction of the power, and an LED that lasts fifteen years beats a halogen needing a new bulb every eighteen months, especially when that bulb sits inside a fixture buried in a garden bed in February. Third, light the path before the trees — a lit path keeps you upright. Uplights on a cedar look lovely in a photograph. A lit path keeps you upright in January. Do the practical lights first. Add the pretty ones when the budget allows, once the practical ones are in.

If the lights are part of a bigger backyard plan, mind the order — the wrong stage costs twice as much. Lighting goes in after the deck and the patio, and before the planting, because the cable runs under the beds and anything planted first gets dug up again. Our guide to deck building cost in Abbotsford covers the deck side, and if the panel needs room for a new lighting circuit, our guide to electrical panel upgrade cost in BC covers that cost too. Read both before you sign a lighting quote that assumes the panel has space it may not have — the real one can look very different.

Frequently Asked Questions About Outdoor Lighting Installation Cost in BC

How much does outdoor lighting cost in BC in 2026? A small low-voltage system of eight to twelve fixtures generally runs $2,500 to $6,000 installed, transformer included. A mid-size system of fifteen to twenty-five fixtures generally runs $6,000 to $12,000 — and that band is where most Fraser Valley yards land. A large or line-voltage-heavy job can reach $12,000 to $20,000 or more once trenching and panel work are in — higher still on a big lot. Per-fixture prices run $180 to $550 by fixture type, with path lights at the low end.

Is low-voltage or line-voltage lighting cheaper? Low-voltage is usually cheaper, both for the fixtures and for the install, because the cable sits shallow, the work is simpler, and nobody has to open a wall for a wire. Line-voltage costs more per fixture and needs a licensed electrician, plus deeper burial or conduit — and that is where the extra hours stack up. Most yards use low-voltage in the garden and line-voltage on the house — each system doing its own job, which keeps the bill reasonable.

How much does a transformer cost for landscape lighting? Supplied and installed, a basic 150-watt transformer generally runs $300 to $700, which covers most small systems. A 300-watt unit with a timer and photocell runs $500 to $1,000 — and the photocell earns its keep in November. A 600-watt or multi-zone unit for a big lot runs $900 to $1,800 — supplied and installed, with room to grow. Buy the next size up from what you need today, so there is room to add lights later — no new box, no second install.

How much do exterior pot lights cost in BC? A single exterior pot light in a soffit, installed, generally runs $280 to $550 — access deciding the spread. A run of six under the eaves can cost $1,700 to $3,300 or more, depending on attic access and a vaulted ceiling. Wet-rated fixtures cost more and last longer under Fraser Valley rain — worth remembering in November.

Do I need a permit for outdoor lighting in Abbotsford? A low-voltage garden system usually needs no building permit — the cable sits a few inches deep, and the voltage is low. A new line-voltage circuit or a panel change may need an electrical permit, and the work should be done by a licensed electrician — not the place to cut corners. Check with your municipality before work starts, since the rules vary by city, and Abbotsford’s answer is not Langley’s.

That porch light in East Abbotsford did its best, and it was never going to be enough for a whole yard, no matter how bright the bulb. The fix is not one bright floodlight. It is a set of small lights in the right places, on a transformer with room to grow, wired by someone who measured the cable runs before they quoted. Outdoor lighting installation cost BC rewards the same habit as every other renovation in this valley. Price the ground and the wiring, not just the fixtures in the showroom — the digging moves the number. Want a straight answer for your own yard, measured against your ground, not a showroom price? Call (236) 613-0038 and talk it through before you order anything, so the quote fits your yard and your ground.